GNUstep SVN Installation Guide
Jump to navigation
Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
This page is a step-by-step "Howto compile the last svn version of GNUstep". It's mainly a short summary of different documents available (and for some too out-of-date). Wiki based, I hope this document will be the up-to-date installation guide.
Introduction
Three step are needed to build and install GNUstep from scratch :
- Building the Makefile package: this set up an environement to build everything else.
- Building library.
- Minimal configuration.
Building Makefile package:
svn co http://svn.gna.org/svn/gnustep/tools/make/trunk/ gnustep-make ./configure --prefix=/usr/GNUstep make make install
Extra configuration needed every time you use "GNUstep" from a command-line: . /usr/GNUstep/System/Library/Makefiles/GNUstep.sh or source /usr/GNUstep/System/Library/Makefiles/GNUstep.csh
Building Library:
svn co http://svn.gna.org/svn/gnustep/libs/base/trunk/ gnustep-base ./configure make make install
svn co http://svn.gna.org/svn/gnustep/libs/gui/trunk/ gnustep-gui ./configure make make install
svn co http://svn.gna.org/svn/gnustep/libs/back/trunk/ gnustep-back ./configure --enable-graphics=cairo --with-name=cairo --disable-glitz make make install
Minimal configuration:
defaults write NSGlobalDomain GSBackend libgnustep-cairo
You may also need to install package to use default font used by GNUstep. On Debian Etch, install ttf-bitstream-vera package.